An Introductory Guide To TeleNet Commands I don't know how many of you use TeleNet to call this system (or other systems) but I thought this might come in handy for those that do. Some basic info about TeleNet commands. To enter a TeleNet you must be at the TeleNet prompt "@". You can get there two ways: 1) When you first dial TeleNet you will be at the prompt 2) When connected to a system via TeleNet you can return to TeleNet command mode by typing "@" (See note A.) Once you get to the prompt here are some of the commands available to you and a brief description of what they do. Command Function ------------------------------------------------------------------------- C xxxxxxx Connects you to a specific host or terminal. STAT Display network port address. FULL Set full duplex HALF Set half duplex DTAPE Prepares the network for bulk file transfers. CONT Return to transfer mode from command mode. BYE or D Disconnects you from the currently connected host. HANGUP Tells TeleNet to hang up the phone.... TERM xx Changes your terminal type. xx can be one of the following: D1 = CRT's and Personal Computers B3 = Bi-directional printers A2 = Uni-directional printers A5 = Slow printing terminal which loses data on the left side at another setting. A9 = same as A5 = Unknown MAIL or Requests connection to Telemail. TELEMAIL TEST CHAR Used to test the system if you are receiving garbled output. Use this and look for garbled characters or patern breaks. If you do try adjusting your parity or contact TeleNet. TEST ECHO If you feel your input to the system is being garbled by your parity or contact TeleNet.